Description: This lab exercise demonstrates the necessary commands to enable and disable spanning tree protocol on a switch.
Network Diagram:
Instructions:
1. Enter into configuration mode on SW1
2. Issue command "spanning-tree vlan <vlan-num> to enable spanning-tree on a specified VLAN
3. Issue no form of the command "spanning-tree vlan <vlan-num> to disable spanning-tree on the VLAN specified.
Note: Please refer to the SimulationExams.com Sim-Ex™ Lab Simulator for Network+ software to try complete lab with instructions.
Disclaimer: Simulationexams.com is not affiliated with any certification vendor, and Sim-Ex™ Practice Exams are written independently by SimulationExams.com and not affiliated or authorized by respective certification providers. Sim-Ex™ is a trade mark of SimulationExams.com or entity representing Simulationexams.com.Network+™ is a trademark of CompTIA® organization.
