Description: You configure a few switch ports for duplex. Choose 2950 switch from the network diagram and exit. The following commands are used for configuring the switch ports.
Instructions:
1. Set the inter-switch communication to full-duplex on Switch S1, port fa 0/26
2. Set the port speed to 100 mbps, and inter-switch communication to full-duplex on Switch S2 ports fa 0/1, fa 0/2, and fa 0/3
3. Exit to privileged mode
4. Save the configuration to NVRAM
Note: Please refer to the SimulationExams.com Sim-Ex Lab Simulator for Network+ software to try complete lab with instructions.
Disclaimer: Simulationexams.com is not affiliated with any certification vendor, and Sim-Ex™ Practice Exams are written independently by SimulationExams.com and not affiliated or authorized by respective certification providers. Sim-Ex™ is a trade mark of SimulationExams.com or entity representing Simulationexams.com.Network+™ is a trademark of CompTIA® organization.
