Description: This lab exercise demonstrates the necessary commands to configure the root switch.
Instructions:
1. Enter into configuration mode on SW1
2. Issue the command "spanning-tree vlan <vlan-num> root" that modifies the switch priority from the default 32768 to a lower value to allow the switch to become the root switch for VLAN1
3. Verify the configuration using “show spanning-tree” command.
Note: Please refer to the SimulationExams.com Network+ Lab Simulator software to try complete lab with instructions.
Disclaimer: All Simulation Exams practice tests, study guides and/or material are neither sponsored by, nor endorsed by, nor affiliated with CompTIA® or any other company. All trademarks are trademarks of their respective owners and duly acknowledged. A+™, Network+™, i-Net+™, Server+™,Security+™ are registered trade marks of CompTIA®. The practice tests material is a copyright of SimulationExams.com and the same is not approved or endorsed by respective certifying bodies. Thank-you for your interest in Simulation Exams. Please see read me file before you download, install, and/or use any software from SimulationExams.com For any information or questions regarding this Website, please e-mail webmaster at simulationexams.com