Q5. What is the command used to enable Multple Spanning Tree (MST) on a Cisco switch?
A. switch(config-if)# spanning-tree portfast
B. switch(config-if)# spanning-tree mst
C. RESTCONF
D. switch(config)# spanning-tree mode mst
E. switch(config)# spanning-tree mst configuration
Correct Answer: C and E
Explanation:
To configure Rapid Spanning Tree Protocol (RSTP) on an edge port, use the command
Switch(config-if)#spanning-tree portfast.
To enable Multiple Spanning Tree (MST) on a switch, use the command
Switch(config)#spanning-tree mode mst
To enter MST configuration mode on a switch, use the command
Switch(config)#spanning-tree mst configuration
Disclaimer: All Simulation Exams practice tests, study guides and/or material are neither sponsored by, nor endorsed by, nor affiliated with Cisco® Systems or any other company. All trademarks are trademarks of their respective owners and duly acknowledged. CCNA™, CCENT™, ICND2™, CCNP™, CCIE™ are registered trade marks of Cisco®Systems. The practice tests material is a copyright of SimulationExams.com and the same is not approved or endorsed by respective certifying bodies. Thank-you for your interest in Simulation Exams. Please see read me file before you download, install, and/or use any software from SimulationExams.com For any information or questions regarding this Website, please e-mail webmaster at simulationexams.com