Sim-Ex™ Lab Simulator for Network+ : Lab Exercises

DHCP client configuration

Previous   |   Next

Description: This lab exercise demonstrates DHCP client configuration i.e, Configuring an interface on the router to use DHCP to acquire its IP address.

Network Diagram:

Network+ Lab Sim image

Instructions:

1. Before proceeding with the DHCP client configuration, make sure that DHCP server is configured as shown in the previous lab exercise.

2. Enter into interface configuration mode on router R2 with appropriate commands.

3. Use the command "ip address dhcp" that configures the specified interface to acquire its IP Address from the DHCP server, verify the same using "show ip interface brief" on the router.

 

Note: Please refer to the SimulationExams.com Sim-Ex™ Lab Simulator for Network+ software to try complete lab with instructions.

Previous   |   Next


Disclaimer: Simulationexams.com is not affiliated with any certification vendor, and Sim-Ex™ Practice Exams are written independently by SimulationExams.com and not affiliated or authorized by respective certification providers. Sim-Ex™ is a trade mark of SimulationExams.com or entity representing Simulationexams.com.Network+™ is a trademark of CompTIA® organization.