Frequent Questions      

 

Download Network+ Lab Simulator   |    Available Labs

Configuring Default Route

Previous   |   Next

 
  Description: ip default-gateway command is used when ip routing is disabled on a Cisco router. The ip default-network and ip route 0.0.0.0 0.0.0.0 commands are used to set the gateway of last resort on Cisco routers that have ip routing enabled.

Command Syntax:  

1. ip default-gateway <ip address> Ex: ip default-gateway 192.168.14.2

2. ip default-network <ip address> Ex: ip default-network 192.168.1.0

3. ip route 0.0.0.0 0.0.0.0 <ip-address> Ex: ip route 0.0.0.0 0.0.0.0 192.168.5.1

Here 192.168.5.1 is the gateway of last resort to network 0.0.0.0

 

Note: Please refer to the SimulationExams.com Network+ Lab Simulator software to try complete lab with instructions.

Previous   |   Next

 

Copyright 2000-2017 SimulationExams.com All rights reserved

Website design by Anandsoft.com

Disclaimer: All Simulation Exams practice tests, study guides and/or material are neither sponsored by, nor endorsed by, nor affiliated with CompTIA or any other company. All trademarks are trademarks of their respective owners and duly  acknowledged. A+, Network+, i-Net+, Server+,Security+ are registered trade marks of CompTIA. The practice tests material is a copyright of SimulationExams.com and the same is not approved or endorsed by respective certifying bodies. Thank-you for your interest in Simulation Exams. Please see read me file before you download, install, and/or use any software from SimulationExams.com  For any information or questions regarding this Website, please e-mail webmaster at simulationexams.com