Frequent Questions      

     
 Home > Network+ Lab Simulator > Available labs > Troubleshooting IP settings
     
 

Download Network+ Lab Simulator   |    Available Labs

Troubleshooting IP settings on WS1 by using ping command


Previous    |   Next

 
  Description: Troubleshooting IP settings on WS1 by using ping command (Ping from WS1 to ISP router at 200.202.1.51 Verify whether the Gateway address is properly configured.)

For this purpose, assign following for interface E0 on router R1

 IP address  192.168.1.1
 subnet mask  255.255.255.0

assign following for interface S0 on R1

 IP address  200.202.1.51
 subnet mask 255.255.255.0

And, Mis-configure Gateway on WS1 to 192.168.0.1 

Network Diagram:

Note: Please refer to the SimulationExams.com Network+ Lab Simulator software to try complete lab with Instructions.

Previous    |   Next

 

Copyright 2000-2017 SimulationExams.com All rights reserved

Website design by Anandsoft.com

Disclaimer: All Simulation Exams practice tests, study guides and/or material are neither sponsored by, nor endorsed by, nor affiliated with CompTIA or any other company. All trademarks are trademarks of their respective owners and duly  acknowledged. A+, Network+, i-Net+, Server+,Security+ are registered trade marks of CompTIA. The practice tests material is a copyright of SimulationExams.com and the same is not approved or endorsed by respective certifying bodies. Thank-you for your interest in Simulation Exams. Please see read me file before you download, install, and/or use any software from SimulationExams.com  For any information or questions regarding this Website, please e-mail webmaster at simulationexams.com