Frequent Questions      

   
 Home > Network+ Lab Simulator > Available labs > Design a PC-to-PC network
   
 

Download Network+ Lab Simulator   |    Available Labs

Design a PC-to-PC network using a Cross-over Ethernet cable and check communication

Previous   |   Next

  Description: Design a PC-to-PC (or workstation to workstation) network using a Cross-over Ethernet cable and check communication.

Task: Design a network with two workstations WS1, WS2 connected via Ethernet Cable (Cross) as shown in the figure.

Use the Lab network designer to design the given network. Use Lab simulator to configure IP address, Subnet mask, and Gateway on WS1 and WS2. Use ping command to verify communication.

 

Network Diagram:

Note: Please refer to the SimulationExams.com Network+ Lab Simulator software to try complete lab with Instructions.

Previous   |   Next

 

Copyright 2000-2017 SimulationExams.com All rights reserved

Website design by Anandsoft.com

Disclaimer: All Simulation Exams practice tests, study guides and/or material are neither sponsored by, nor endorsed by, nor affiliated with CompTIA or any other company. All trademarks are trademarks of their respective owners and duly  acknowledged. A+, Network+, i-Net+, Server+,Security+ are registered trade marks of CompTIA. The practice tests material is a copyright of SimulationExams.com and the same is not approved or endorsed by respective certifying bodies. Thank-you for your interest in Simulation Exams. Please see read me file before you download, install, and/or use any software from SimulationExams.com  For any information or questions regarding this Website, please e-mail webmaster at simulationexams.com