Frequent Questions      

     
 Home > Network+ Lab Simulator > Available labs > Configuring Wireless Security
     
 

Download Network+ Lab Simulator   |    Available Labs

Configuring Wireless Security on an Access Point (WEP)

Previous   |   Next

 
  Description: Configuring Wireless Security on an Access Point (WEP).

Task: Configure WEP security on AP Verify that the communication will not take place between the PCs (PC1 and PC2) until the WEP key is provided. Use ping command to ping the Access Point (AP) fro WS1. AP IP address: 192.168.1.131 subnet mask: 255.255.255.128

Network Diagram:

Note: Please refer to the SimulationExams.com Network+ Lab Simulator software to try complete lab with instructions.

Previous   |   Next

 

Copyright 2000-2017 SimulationExams.com All rights reserved

Website design by Anandsoft.com

Disclaimer: All Simulation Exams practice tests, study guides and/or material are neither sponsored by, nor endorsed by, nor affiliated with CompTIA or any other company. All trademarks are trademarks of their respective owners and duly  acknowledged. A+, Network+, i-Net+, Server+,Security+ are registered trade marks of CompTIA. The practice tests material is a copyright of SimulationExams.com and the same is not approved or endorsed by respective certifying bodies. Thank-you for your interest in Simulation Exams. Please see read me file before you download, install, and/or use any software from SimulationExams.com  For any information or questions regarding this Website, please e-mail webmaster at simulationexams.com