Frequent Questions      

 

Download Network+ Lab Simulator   |    Available Labs

Configuring the switch priority of a VLAN

Previous   |   Next

 
  Description: This exercise demonstrates the command required to configure switch priority of a VLAN.

Instructions:

1. Enter into configuration mode on SW1

2. Issue the command "spanning-tree vlan <vlan-id> priority <priority-value> to configure the switch priority of a VLAN and verify the same using “show spanning-tree” command.

Note: The switch priority can be configured thus making it more likely to be chosen as the root switch. Priority range is 0 to 61440 in increments of 4096, default is 32768.

 

Note: Please refer to the SimulationExams.com Network+ Lab Simulator software to try complete lab with instructions.

Previous   |   Next

 

Copyright © 2000-2017 SimulationExams.com All rights reserved

Website design by Anandsoft.com

Disclaimer: All Simulation Exams practice tests, study guides and/or material are neither sponsored by, nor endorsed by, nor affiliated with CompTIA® or any other company. All trademarks are trademarks of their respective owners and duly  acknowledged. A+™, Network+™, i-Net+™, Server+™,Security+™ are registered trade marks of CompTIA®. The practice tests material is a copyright of SimulationExams.com and the same is not approved or endorsed by respective certifying bodies. Thank-you for your interest in Simulation Exams. Please see read me file before you download, install, and/or use any software from SimulationExams.com  For any information or questions regarding this Website, please e-mail webmaster at simulationexams.com