CCNA Simulation Practice Exercise - Configure console password and vty password

Previous    |    Index    |    Next

Description: We configure console password and vty password in this exercise. Use enable password enpass, enable secret password secpass, console password of conspass and vty password of "vtypass"

Instructions:

1. Enter global configuration mode

2. Set the enable password to "enpass"

3. Set the enable secret to "secpass"

4. Set the console password to "conspass" for line console 0

5. Set the telnet access password to "vtypass" for line vty 0-4

6. Exit the line configuration mode

Please enter FULL command. Kindly note that short form commands are not supported by the simulation software at this time. Type the commands and press enter or click ok button. All Commands are case sensitive.


















  

For any comments / suggestions, please email webmaster[at]simulationexams.com


Disclaimer: Simulationexams.com is not affiliated with any certification vendor, and Sim-Ex™ Practice Exams are written independently by SimulationExams.com and not affiliated or authorized by respective certification providers. Sim-Ex™ is a trade mark of SimulationExams.com or entity representing Simulationexams.com.CCNA™ is a trademark of Cisco® systems