Frequent Questions      

 Home > Network+ Lab Simulator > Available labs > Configuring Static Routes

Download Network+ Lab Simulator   |    Available Labs

Configuring Static Routes

Previous   |   Next

  Description: Configure static route mask with next hop address of

Syntax: ip route prefix mask {address|interface} [distance]

prefix mask: It is the ip route prefix and mask for the destination.

address|interface: Use either the next hop router ip or the local router outbound interface used to reach the destination.

distance: It is the administrative distance and an optional parameter.


1. Enter into Global Configuration Mode

2. Disable IP Routing

3. Re-enable IP Routing

4. Configure a static route with destination sub network number as, subnet mask as,and IP address of the next-hop router in the destination path to


Note: Please refer to the Network+ Lab Simulator software to try complete lab with instructions.

Previous   |   Next


Copyright 2000-2018 All rights reserved

Website design by

Disclaimer: All Simulation Exams practice tests, study guides and/or material are neither sponsored by, nor endorsed by, nor affiliated with CompTIA or any other company. All trademarks are trademarks of their respective owners and duly  acknowledged. A+, Network+, i-Net+, Server+,Security+ are registered trade marks of CompTIA. The practice tests material is a copyright of and the same is not approved or endorsed by respective certifying bodies. Thank-you for your interest in Simulation Exams. Please see read me file before you download, install, and/or use any software from  For any information or questions regarding this Website, please e-mail webmaster at