Frequent Questions      

     
 Home > Network+ Lab Simulator > Available labs > Configuring Port-Priority
     
 

Download Network+ Lab Simulator   |    Available Labs

Configuring Port-Priority

Previous   |   Next

 
  Description: This lab exercise demonstrates configuring port-priority for an interface on a switch.

Instructions:

1. Enter into interface configuration mode on SW1

2. Issue the command "spanning-tree port-priority <priority-value> to configure port-priority on the specified interface

3. Use the command "show spanning-tree vlan <vlan-id>" to verify the configuration

 

Note: Please refer to the SimulationExams.com Network+ Lab Simulator software to try complete lab with instructions.

Previous   |   Next

 

Copyright 2000-2017 SimulationExams.com All rights reserved

Website design by Anandsoft.com

Disclaimer: All Simulation Exams practice tests, study guides and/or material are neither sponsored by, nor endorsed by, nor affiliated with CompTIA or any other company. All trademarks are trademarks of their respective owners and duly  acknowledged. A+, Network+, i-Net+, Server+,Security+ are registered trade marks of CompTIA. The practice tests material is a copyright of SimulationExams.com and the same is not approved or endorsed by respective certifying bodies. Thank-you for your interest in Simulation Exams. Please see read me file before you download, install, and/or use any software from SimulationExams.com  For any information or questions regarding this Website, please e-mail webmaster at simulationexams.com